The following information was tested and approved with a MatchingCube-A. That is a model that employs air capacitors.

For general information on optimizing the loop parameters refer to: How to set control loop parameters.

In order to decrease the matching time the most important parameters are:

• Maximum Step Sizes: CT
• Maximum Step Sizes: CL

Increase Maximum Step Sizes step by step to the maximum of:

• CT: 100
• CL: 250

In case any instabilities occur: Decrease the Maximum Step Sizes immediately!

© barthel HF-Technik GmbH 2024 – T +49 (0)241 45015-40 – Imprint & Privacy